The hammer crusher is one of our leading products. It is used for crushing raw materials that have compressive strength less than 150MPa such as limestone, marl, sandstone, gypsum, coal, etc.

1.Tri-cavity curved designed, which increased the breaking times of materials. The "rock-on-rock" principle reduce the friction, wear of hammers and also consumption of energy.

2. High crushing ratio , small granularity (D80≤8mm)

3. Energy saving over 40% than multi-stage crushers.

4. Long service life, lower cost of operation, maintenance .

5. Easy adjusting of discharging grid plate.

6. 20 mins can finished the complete checkup for the equipment by one person.

1. the fed lump ore will pile up at the middle of special designed bracket, hammers rotating in the gaps of bracket , lump ore will fall down after continuous crushing , the crushed small materials will gride again by high speed rotated hammers ,the discharging from the grid plate.

2. Security

The stability of heavy bob bar linkage of discharging gate , the performance of rotation hammers and adjustment of grid plate have been proved by many users by years works.

3. stability

Discharging grid plate can be adjusted easily outside the frame , which can make sure the wear parts have long service life and always work in good conditions.